micro cast film Line

Produce representative test films in minutes while using only a small fraction of material compared with conventional lab-scale lines. Ideal when sample is limited or additives are costly (e.g., nanotubes, active ingredients), this setup enables rapid screening of formulations with minimal waste.

Key features

• Optional continuous-feed kit (mountable hopper + feed screws) supports longer runs and very long films via continuous extrusion.

• Capable of casting film or sheet from small samples; integrated air-knife/chill take-off typically supports widths in the ~30–40 mm range (material-dependent).

• Wide draw-speed range with fine setpoint increments; torque-controlled winder maintains tension as roll diameter increases.

• When paired with a micro-compounder or melt-pump/throughput control, the line delivers uniform, repeatable thickness without bulky gear-pumps.

• Under optimized conditions, ultra-thin films on the order of a few micrometers are achievable.*

  * Actual performance depends on configuration, material, and processing conditions.